USB AVRISP CH, Внутрисхемный программатор AVR-микроконтроллеров

Features

• Resolution
  • Using the same MCU and core circuit as AT AVRISP, easy to use, stable and reliable
  • Based on ATMEL official STK500 firmware, identified as AVRISP/STK500 in AVRStudio, high speed programming
• StandardISP_6PINconnector
• CH340G USB to UART converter, supports most popular OS, including WIN10, more stable, faster programming
• Supports AVR Studio 4/5/6/7
• Supports0~3.6864MHz frequency output (via the two through holes on the backside, round=GND, square=PCLK, frequency is configurable by software)

Supported Software

• AVR Studio or WINAVR(GCC) is used as front-end software
• Supports files generated by IAR, ICCAVR, CVAVR, etc.

Supported Devices

Same as AT AVR ISP:

• Supports most AVR MCU with ISP programming option
• Supports AT86RF401/AT89S51/AT89S52 (when programming S51/S52, the MCU.RESET is recommended to be connected with the programmer, not the external reset circuit)

Refer to AVRStudio 4.18 SP3, the following devices are supported:

Performance

• High speed programs FLASH ROM, EEPROM, Fuses, and Lock Bit
• It takes only 5.5s to program a 45K program file with verification (the test MCU uses 8MHz external crystal, and programming speed is set as 1.8MHz)

Connects to PC

• Uses a quasi-USB interface (USB To COM)
• The COM port is configurable, a PC could connects to several USB AVRISP CH at the same time

Note: the COM port should be configured as COM1-COM4 for the first time, refer to the user manual for more details.

Connects to the Target Board

The USB AVRISP CH connects to the target board through 3 optional cables. Depending on the existed connector on the target board, the cable has to be changed accordingly.

• For standard 6-pin ISP connector, use the default 6-pin ISP cable, the header pinout is shown in the figure below:
• For standard 10-pin ISP connector, use 6-pin to 10-pin ISP cable, the header pinout is shown in the figure below:
• For custom ISP connector, use the 6-wire multicolour separated cable

Note: the programmer is powered from USB connection, however, it will not power the target board, which should be powered from another supply.

Development Resources

Wiki : www.waveshare.com/wiki/USB_AVRISP_CH

Selection Guide

Комплект поставки

1. USB AVRISP CH x1
2. USB cable x1
3. 6-pin to 10-pin ISP cable x1
4. 6-wire multicolour separated cable x1

1

2

3

4