Ориентировочная стоимость (Время доставки и итоговая стоимость согласуются индивидуально с каждым клиентом):
Товар весом до 10 кг - 500 ₽
Товар весом свыше 10 кг - 800 ₽
Стоимость доставки зависит от города назначения и размера посылки. Вы можете самостоятельно рассчитать стоимость доставки на сайтах транспортных компаний.
Выдача товара производится согласно графика работы:
Пн-Чт: с 9:00 до 18:00
Пт: с 9:00 до 17:00
Обед с 13:00 до 14:00 - выдача товара не производится.
Вы можете оплатить заказ следующими способами:
Features
|
Based on JTAGICE mkII from ATMEL - Fully compatible with JTAGICE mkII, easy to use, stable and reliable Based on JTAGICE mkII firmware - Identified as JTAGICE mkII in AVRStudio, high speed debugging and programming Upgradable firmware- Firmware is upgradable to Support Future Devices- Automatic Upgrade Supported software - AVR Studio 4/5/6, WINAVR(GCC) or IAR is used as front-end software - Supports the program files generated by ICCAVR, CVAVR, IAR Device Support - Supports debugging and programming of all AVR and AVR32 devices with JTAG, PDI, debugWIRE Interface Refer to AVR Studio 6, the following devices are supported:
Supports all the different voltages and speed grade versions of the devices listed in the table above. Check more supported devices : UC3,Mega,SAM,Tiny,Xmega Performance - On-Chip Debugging: Run, Single step, Breakpoints, etc. Allows the user to view the internal state of the device. - High speed Debugging - Programming Interface to flash, eeprom, fuses and lockbits (not debugWIRE) - Low speed programming through ISP, or high speed programming through JTAG Connecting to PC Before connecting up the JTAGICE XPII for the first time, be sure to install the USB driver on the host computer. This is done automatically when installing the front-end software (Probably AVR Studio). The JTAGICE XPII can connect to the host PC through a USB cable or serial cable (to COM port on the PC) - Each JTAGICE XPII has a unique ID, a PC could connects to several Devices at the same time - USB Interface: use the PDIUSBD12, USB 1.1 - RS-232 Interface: use the 9-pin RS-232 cable. Make sure that no other software has control of the COM port where the JTAGICE XPII is connected. The rear panel of the JTAGICE XPII houses the DC jack, power switch, USB and RS-232 connectors. Connects to target board Debugging Interface: JTAG, PDI, debugWIRE (SPI), depending on which interface the target devices with. Programming Interface: JTAG, PDI, ISP (SPI), depending on which interface the target devices with. The cable has to be changed according to the existed header on the target board. See Details displayed bellow.
The figure 1, 2, 3 and 4 shows the header pinouts of different interfaces
Powering the JTAGICE XPII - Operates using an external power supply providing 9-15V DC - Can be powered directly from the USB bus - The target board should be powered from Another Power Supply |
Development resources:user guide, software, etc. Wiki:www.waveshare.com/wiki/USB_AVR_JTAGICE_XPII
Note: 9-15V power supply adapter is NOT included.